iniBuilds has recently released an update for their Airbus A300-600R add-on for Microsoft Flight Simulator. The new version, v1.1.1, includes various fixes for systems, art, sounds, among others.

However, to get this update out quickly, iniBuilds has temporarily disabled the SEC FLPN feature, which they plan to re-enable in the next update scheduled for release next week.

The new version has a significant changelog with numerous fixes, which are listed below:

‍

v1.1.1

‍

Systems

Fixed - [VNAV] When in the turn VDEV reporting low on path but ending high after turn complete 

Fixed - [SYS] When pressing N1 mode no ECAM is shown

Fixed - [ENG] OIL TEMP to not be based on EGT

Fixed - Double pressing +/- on IDC doesn't' switch between a + and -, just inserts + every time 

Fixed - [IDC] AOC Enroute - Pos Rpt unable to change fuel from KG to LBS, regardless of units selected on EFB

Fixed - [IDC] Squawk IDENT on ATC/TCAS CONTROL page doesn't send ident command to Vpilot

Fixed - F-PLN B page when RSK should take to VERT REV B page also

Fixed - [IDC]TCAS "TA ONLY" state doesn't show an indication in the TCAS control page

Fixed - [SYS] ECAM TCAS STBY memo does not appear when ALT RPTG ON

Fixed - [SYS] No Bleed air pressure indication with APU Bleed ON, ENG OFF

Fixed - [SYS] Bleed air pressure gauge gets stuck to last value when R ENG BLEED = OFF

Fixed - Can't step through ATLN/SEC F-PLNs

Fixed - BRG/DIST should be to 1 decimal place

Fixed - TO Config should read NORM FOR T/O

Fixed - TCAS showing traffic at wrong relative altitude

Fixed - STAR selection code crash

Fixed - EFIS dials (DH, FPA) can be adjusted with FCU off

Fixed - F-PLN B page wind format 

Fixed - [FMGS] Speeds in plan do not account for transition alt

Fixed - [ENG] N2 speed during crank

Fixed - Manual changes to INIT B should be big font

Fixed - Pressing GPWS switch when alert is active does not cancel warnings

Fixed - PACKS OFF Operations

Fixed - AP/AT Disconnect switches not animated via control input

Fixed - [VNAV] Aiming for CST too early 

Fixed - If a message is open on one idc, sending a message from the other messes with the message displaying IDC

Fixed - ORIG/DEST have no input sanitisation

Fixed - Switching panel button behaviour

Fixed - Should be possible to modify sps/alt/wind dir/temp directly on F-PLN

Fixed - Should be able to dial in a speed when in PROF like in the A320 for when you switch to LVL CHG or VS

Fixed - Unable to change LAT/LON with slew keys INIT A

Fixed - Navaid/REF pages

Fixed - MCDU F-PLN page additions and corrections

Fixed - IMM DESC is started with any right LSK on F-PLN page

Fixed - Des arrow is few pixels off again

Fixed - Wrong bearings on SID (FACT RWY19 TETAN 1A SID)

Fixed - Tiller getting stuck left when used via rudder axis

Fixed - [IDC] COM Presets not saving either Com1 or Com2

Fixed - Throttle locks to idle after turning off autothrust

Fixed - [SYS] CTD/Plane stops responding when deleting HOLD/Waypoint from PROC in MCDU

Fixed - Should be possible to modify sps/alt/wind dir/temp directly on F-PLN

Fixed - ENG 2 PW EGT max pointer needle doesn't move

Fixed - MCDU F-PLN page additions and corrections

Fixed - Wrong bearings on SID (FACT RWY19 TETAN 1A SID)

Fixed - PFD errors

Fixed - Oil level mismatch on PW variant

Fixed - FMS number rounding

Fixed - ANTI SKID release indicators in flight on the wheel page are missing

Fixed - Door SD Page improvements 

‍

Art

Fixed - Cargo compartment smoke detection switch animation issue

Fixed - APU exhaust still visible after being shut down

Fixed - Missing GPWS Landing Flaps/ Slats selector switch text

Fixed - [ART] Using the IDC panel - lose the lettering and the illumination around the ILS and VOR frequencies

Fixed - [ART][PW] Eng 2 EGT Orange Needle INOP

Fixed - [ART] Weird shadow on IGN/APU panel buttons

Fixed - EGT warning light on GE engine config lighting up at PW limits

Fixed - [ART] FO/CAPT switching lower sys indications should be boxed

Fixed - Squib emissive should be white, not amber

Fixed - [ART] FO Switching panel has red lines on buttons when CAPT side switching is set to SYS3

Fixed - Engine 1 Pylon labels mirrored

Fixed - [ART] PW Pax house livery on the nose says Freighter (600RF instead of 600R)

Fixed - [PW] Pilots Model missing from external view

Fixed - Cabin light resets when zooming out

‍

Sounds

Fixed - GPWS test plays in C&D 

Fixed - Alt alert C chord cuts off early if you rapidly adjust the alt knob on the ground

Fixed - [SOUND] Exterior view engine sounds fade in and out

Fixed - PW sounds on fuel injection

Fixed - Increase ATC COM telex volume

Fixed - RA Callouts playing on panel state change

Fixed - Horizontal Stabilizer Trim animation inverted

Fixed - Engine sounds disappear too fast on shut down

Fixed - Sound Mix Feedback

‍

EFB

Fixed - Pax EFB has toggle catering option avail in the air

Fixed - [EFB] On-screen keyboard only shows numbers for HOPPIE field on settings page

Fixed - [EFB] Enroute map - save/retain zoom level when switching between EFB apps

Fixed - Landing calc RWY graphic units not syncing

‍

Other

Fixed - MSFS Checklist TOGA highlights old ATC COM button click spot

Fixed - CPT PFD brightness typo

The updated Airbus A300-600R is now available on iniManager. It can be purchased from the iniBuilds Store for approximately $44.79 and requires 6.05GB of storage.

For the latest flight simulation news, remember to stay tuned on Threshold!